User Manual
Table Of Contents
- Table of Contents
- Introduction and Scope
- Glossary
- Product Features
- Pepwave MAX Mobile Router Overview
- Installation
- Connecting to Web Admin Interface
- Configuration of LAN Interface(s)
- Configuration of WAN Interface(s)
- Wi-Fi Settings
- Site-to-Site VPN
- Management of Outbound Traffic to WAN
- Port Forwarding
- NAT Mappings
- QoS
- Firewall
- Miscellaneous Settings
- System Settings
- Status
- Restoration of Factory Defaults
- Declaration
http://www.pepwave.com 50 Copyright @ 2011 Pepwave
11.1 Outbound Policy
There are three main selections for the Outbound Policy for Pepwave MAX:
High Application Compatibility
Normal Application Compatibility
Managed by Custom Rules
The selections are explained as follows:
Outbound Policy Settings
High Application
Compatibility
With the selection of this policy, outbound traffic from a source LAN device is
routed through the same WAN connection regardless of the destination Internet
IP address and protocol.
This provides the highest application compatibility.
Normal
Application
Compatibility
With the selection of this policy, outbound traffic from a source LAN device to the
same destination Internet IP address will persistently be routed through the same
WAN connection regardless of protocol.
This provides high compatibility to most applications, and users still benefit from
WAN link load balancing when multiple Internet servers are accessed.
Managed by
Custom Rules
With the selection of this policy, outbound traffic behavior can be managed by
defining custom rules.
Rules can be defined in a custom rule table. A default rule can be defined for
connections that cannot be matched with any one of the rules.
The default policy is Normal Application Compatibility.
Tip
Want to know more about how-to create outbound rules? Visit our YouTube Channel for a video tutorial!
http://www.youtube.com/PeplinkChannel#p/u/2/m977ePdM_sI