User Manual
Table Of Contents
- Table of Contents
- Introduction and Scope
- Glossary
- Product Features
- Pepwave MAX Mobile Router Overview
- Installation
- Connecting to Web Admin Interface
- Configuration of LAN Interface(s)
- Configuration of WAN Interface(s)
- Wi-Fi Settings
- Site-to-Site VPN
- Management of Outbound Traffic to WAN
- Port Forwarding
- NAT Mappings
- QoS
- Firewall
- Miscellaneous Settings
- System Settings
- Status
- Restoration of Factory Defaults
- Declaration
http://www.pepwave.com 48 Copyright @ 2011 Pepwave
10.4 VPN Status
VPN Status is shown in the Dashboard. The connection status of each connection profile is shown as
below:
By clicking the Details button at the top-right hand corner of Site-to-Site VPN table, you will be forwarded
to Status > Site-to-Site VPN. You can view the subnet and WAN connection information of each VPN
peer. Please refer to Section 19.5 for details.
IP subnets must be unique among VPN peers
The entire inter-connected Site-to-Site VPN network is one single non-NAT IP network. No two
subnets in two sites shall be duplicated. Otherwise, connectivity problems will be experienced in
accessing those subnets.