User Manual
Table Of Contents
- Table of Contents
- Introduction and Scope
- Glossary
- Product Features
- Pepwave MAX Mobile Router Overview
- Installation
- Connecting to Web Admin Interface
- Configuration of LAN Interface(s)
- Configuration of WAN Interface(s)
- Wi-Fi Settings
- Site-to-Site VPN
- Management of Outbound Traffic to WAN
- Port Forwarding
- NAT Mappings
- QoS
- Firewall
- Miscellaneous Settings
- System Settings
- Status
- Restoration of Factory Defaults
- Declaration
http://www.pepwave.com 43 Copyright @ 2011 Pepwave
10 Site-to-Site VPN
Pepwave Site-to-Site VPN functionality securely connects your MAX in different branch to another
Pepwave MAX or Peplink device (only Peplink Balance 210/310/380/390/580/710/1350 are available for
this function). The data, voice, or video communications between these locations are kept confidential
across the public Internet.
The Site-to-Site VPN of the Pepwave MAX is specifically designed for multi-WAN environment. The
Pepwave MAX can aggregate all WAN connections’ bandwidth for routing Site-to-Site VPN traffic. Unless
all the WAN connections of one site are down, the Pepwave MAX can still maintain VPN up and running.
VPN Bandwidth Bonding is supported in firmware 5.1+. All available bandwidth will be utilized to establish
the VPN tunnel, and all traffic will be load balanced at packet level across all links. VPN Bandwidth
Bonding is enabled by default.
Tip
You can define firewall rules to control access within the VPN network. Outbound traffic can be redirected
and go through VPN tunnels with custom outbound policies, please refer to section 12 for details
10.1 Configuring a Site-to-Site VPN Profile