User Manual
Table Of Contents
- Table of Contents
- Introduction and Scope
- Glossary
- Product Features
- Pepwave MAX Mobile Router Overview
- Installation
- Connecting to Web Admin Interface
- Configuration of LAN Interface(s)
- Configuration of WAN Interface(s)
- Wi-Fi Settings
- Site-to-Site VPN
- Management of Outbound Traffic to WAN
- Port Forwarding
- NAT Mappings
- QoS
- Firewall
- Miscellaneous Settings
- System Settings
- Status
- Restoration of Factory Defaults
- Declaration
http://www.pepwave.com 41 Copyright @ 2011 Pepwave
Wi-Fi AP Advanced Settings
STP
This option allows you to enable the Spanning Tree Protocol to prevent path
redundancy. By default, it is disabled.
See Section 10.1 for details.
Layer 2
Communication
This option allows you to choose whether clients on the network should be
able to communicate with each other directly.
If the checkbox Enable is selected, clients are allowed to communicate with
each other directly, and traffic will not be passed to any uplink equipment.
If this option is disabled, clients are not allowed to communicate directly.
Traffic will be passed to uplink equipments/uplink routers before
communication can be established among clients.
By default, it is enabled.
802.1X Version
This option allows you to select between V1 or V2 of the 802.1X EAPOL.
When V1 is selected, both V1 and V2 clients are allowed to associate with this
Wi-Fi AP.
When V2 is selected, only V2 clients can associate with this Wi-Fi AP.
Most wireless clients support V2. Select the option V1 in case if there are
stations that do not support V2.
By default, V2 is selected.
Beacon Rate
This option is for setting the transmit bit rate for sending a beacon.
By default, 1Mbps is selected.
Beacon Interval
This option is for setting the time interval between each beacon.
By default, 100ms is selected.
DTIM
This field allows you to set the frequency for the beacon to include Delivery
Traffic Indication Message. The interval is measured in millisecond.
The default value is set to 1 ms.
RTS Threshold
This field allows you to set the minimum packet size for the unit to send an
RTS using the RTS/CTS handshake. Setting this field to zero will disable this
option.
The default value is set to 0.
Slot Time
This field is for specifying the unit wait time before it transmits a packet.
By default, this field is set to 9 µs.
ACK Timeout
This field is for setting the wait time to receive an acknowledgement packet
before performing a retransmission.
By default, this field is set to 48 µs.
CTS Timeout
This field is for specifying the timeout interval for the unit to wait for a CTS
response in the RTS/CTS handshake.
By default, this field is set to 48 µs.