User Manual

http://www.pepwave.com 35 Copyright @ 2011 Pepwave
IP Address /
Subnet Mask /
Default Gateway
/ DNS Servers
This information is obtained from the Wi-Fi access point automatically.
WAN Connection
Name
This field is for defining a name to represent this WAN connection.
Standby State
This setting specifies the state of the WAN connection while in standby. The
available options are Remain Connected (hot standby) and Disconnect (cold
standby).
Health Check
Method
This setting allows you to specify the health check method for the WAN
connection. The available options are Disabled, Ping, and DNS Lookup.
The default method is Disabled.
See Section 9.4 for configuration details.
Bandwidth
Allowance
Monitor
This option allows you to enable bandwidth usage monitoring on this WAN
connection for each billing cycle. When this is not enabled, bandwidth usage of
each month is still being tracked but no action will be taken.
See Section 9.5 for configuration details.
Wi-Fi
Association
Mode
This option is to specify the Wi-Fi access point selection criteria during
association.
When Stronger Signal Strength is selected, the access point that matches one
of the listed Wi-Fi Connection Profiles and has the strongest received signal will
be selected regardless of its profile priority.
When Profile Priority is selected, the access point that matches one of the listed
of Wi-Fi Connection Profiles and has the highest priority will be selected.
By default, Stronger Signal Strength is selected.
Connect to Any
Open Mode AP
This option is to specify whether the Wi-Fi WAN will connect to any open mode
access point it finds. By default, this is disabled.
Reply to ICMP
PING
If this field is disabled, the WAN connection will not respond to ICMP PING
requests.
By default, this is enabled.