User Manual
Table Of Contents
- Table of Contents
- Introduction and Scope
- Glossary
- Product Features
- Pepwave MAX Mobile Router Overview
- Installation
- Connecting to Web Admin Interface
- Configuration of LAN Interface(s)
- Configuration of WAN Interface(s)
- Wi-Fi Settings
- Site-to-Site VPN
- Management of Outbound Traffic to WAN
- Port Forwarding
- NAT Mappings
- QoS
- Firewall
- Miscellaneous Settings
- System Settings
- Status
- Restoration of Factory Defaults
- Declaration
http://www.pepwave.com 30 Copyright @ 2011 Pepwave
8.1.3 PPPoE Connection
This connection method is suitable if ISP provides login ID / password to connect via PPPoE.
PPPoE Settings
IP Address / Subnet
Mask / Default
Gateway
This information is obtained from the ISP automatically.
PPPoE User Name /
Password
Enter the required information in these fields in order to connect via PPPoE to
the ISP. The parameter values are determined by and can be obtained from
the ISP.
Confirm PPPoE
Password
Verify your password by entering it again in this field.
Service Name
Service Name is provided by the ISP.
Note: Leave this field blank unless it is provided by your ISP.
DNS Servers
Each ISP may provide a set of DNS servers for DNS lookups. This setting
specifies the DNS (Domain Name System) Servers to be used when a DNS
lookup is routed through this connection.
Selecting Obtain DNS server address automatically results in the DNS
Servers assigned by the PPPoE server to be used for outbound DNS lookups
over the WAN connection. (The DNS Servers are obtained along with the
WAN IP address assigned from the PPPoE server.)
When Use the following DNS server address(es) is selected, you can put
custom DNS server addresses for this WAN connection into the DNS server
1 and DNS server 2 fields.