User Manual
Table Of Contents
- Table of Contents
- Introduction and Scope
- Glossary
- Product Features
- Pepwave MAX Mobile Router Overview
- Installation
- Connecting to Web Admin Interface
- Configuration of LAN Interface(s)
- Configuration of WAN Interface(s)
- Wi-Fi Settings
- Site-to-Site VPN
- Management of Outbound Traffic to WAN
- Port Forwarding
- NAT Mappings
- QoS
- Firewall
- Miscellaneous Settings
- System Settings
- Status
- Restoration of Factory Defaults
- Declaration
http://www.pepwave.com 22 Copyright @ 2011 Pepwave
7.2 Wi-Fi AP
The Wi-Fi LAN settings can be configured in Network > LAN > Wi-Fi AP:
Wi-Fi AP can also be switched on / off on the Dashboard.
Click Add button to create a new SSID.
Wireless Network Settings
Network Name
(SSID)
This setting allows you to specify a name to represent the virtual AP to be
scanned by Wi-Fi clients.
Enable
When Yes is selected, this virtual AP is enabled. Select No to disable it.
By default, it is enabled.
You can also choose to enable or disable this virtual AP on the Dashboard -
Connection Status of Wi-Fi AP, please refer to section 7 for information.
Broadcast SSID
When the box Enable is checked, this SSID can be scanned by Wi-Fi clients.
By default, it is enabled.
Multicast Filter
When the box Enable is checked, multicast network traffic to the wireless SSID
will be filtered.
By default, it is disabled.
Multicast Rate
This field allows you to specify the transmit rate to be used for sending multicast
network traffic.
By default, Multicast Rate is set to 1M.
Wireless Security Settings
Security Policy
This setting specifies which security policy will be used for this wireless network.
Available options: