User Manual
Table Of Contents
- Table of Contents
- Introduction and Scope
- Glossary
- Product Features
- Pepwave MAX Mobile Router Overview
- Installation
- Connecting to Web Admin Interface
- Configuration of LAN Interface(s)
- Configuration of WAN Interface(s)
- Wi-Fi Settings
- Site-to-Site VPN
- Management of Outbound Traffic to WAN
- Port Forwarding
- NAT Mappings
- QoS
- Firewall
- Miscellaneous Settings
- System Settings
- Status
- Restoration of Factory Defaults
- Declaration
http://www.pepwave.com 18 Copyright @ 2011 Pepwave
Dashboard shows the current WAN, LAN, Wi-Fi AP settings and statuses. You can simply change
priority of WAN connections and switch on / off Wi-Fi AP in here. For further information about how-to set
up these connections, please refer to Section 8 and 9.
Device Information shows the details about the device, including Model name, Firmware version and
Uptime. For further information please refer to Section 19.
Important Note
Configuration changes (e.g. WAN, LAN, Admin settings, etc.) will only take effect after clicking the
Save button at the bottom of each page. The Apply Changes button causes the changes to be saved
and applied.