User Manual
Table Of Contents
- Table of Contents
- Introduction and Scope
- Glossary
- Product Features
- Pepwave MAX Mobile Router Overview
- Installation
- Connecting to Web Admin Interface
- Configuration of LAN Interface(s)
- Configuration of WAN Interface(s)
- Wi-Fi Settings
- Site-to-Site VPN
- Management of Outbound Traffic to WAN
- Port Forwarding
- NAT Mappings
- QoS
- Firewall
- Miscellaneous Settings
- System Settings
- Status
- Restoration of Factory Defaults
- Declaration
http://www.pepwave.com 12 Copyright @ 2011 Pepwave
4.3 MAX HD2
4.3.1 Front Panel Appearance
4.3.2 LED Indicators
The statuses indicated by the Front Panel LEDs are as follows:
Status Indicators
Status
OFF System initializing
Red Booting up or busy
Green Ready state
Wi-Fi AP and Wi-Fi WAN Indicators
Wi-Fi WAN /
Cellular 1 /
Cellular 2
OFF Disabled Intermittent
Blinking Trying to connect but not connected to any wireless network
ON Connected to wireless network(s) without traffic
Continuous Blinking Transferring data
LAN and Ethernet WAN Ports
Green LED
ON 1000 Mbps
OFF 10/100 Mbps
Yellow LED
Solid Port is connected without traffic
Blinking Data is transferring
OFF Port is not connected
Port Type
Auto MDI/MDI-X ports
LAN Ports
Ethernet WAN Port
Wi-Fi WAN Connector
Wi-Fi AP Connector
USB Port
Status LED
Wi-Fi WAN LED
Reset Button
Cellular WAN LED
Terminal Block