User Manual
Table Of Contents
- Table of Contents
- Introduction and Scope
- Glossary
- Product Features
- Pepwave MAX Mobile Router Overview
- Installation
- Connecting to Web Admin Interface
- Configuration of LAN Interface(s)
- Configuration of WAN Interface(s)
- Wi-Fi Settings
- Site-to-Site VPN
- Management of Outbound Traffic to WAN
- Port Forwarding
- NAT Mappings
- QoS
- Firewall
- Miscellaneous Settings
- System Settings
- Status
- Restoration of Factory Defaults
- Declaration
http://www.pepwave.com 10 Copyright @ 2011 Pepwave
4.2 MAX 700
4.2.1 Front Panel Appearance
4.2.2 LED Indicators
The statuses indicated by the Front Panel LEDs are as follows:
Status Indicators
Status
OFF System initializing
Red Booting up or busy
Green Ready state
Wi-Fi AP and Wi-Fi WAN Indicators
Wi-Fi WAN
OFF Disabled Intermittent
Blinking Trying to connect but not connected to any wireless network
ON Connected to wireless network(s) without traffic
Continuous Blinking Transferring data
Wi-Fi AP
OFF Disabled Intermittent
Blinking Enabled but no client associated
ON Client(s) associated to wireless network
Continuous Blinking Transferring data to wireless network
LAN Ports
Ethernet WAN Port
Wi-Fi WAN Connector
Wi-Fi LAN Connector
USB Port
Wi-Fi AP LED
Wi-Fi WAN LED
Reset Button
Power LED
Terminal Block
Status LED