User's Manual

Pepwave MAX and Surf User Manual
http://www.pepwave.com
167
Copyright @ 2015 Pepwave
Appendix B. Declaration
1. The device supports time division technology
2. Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
- Consult the dealer or an experienced radio/TV technician for help.FCC Caution: Any
changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Operations in the 5.15-5.25GHz band are restricted to indoor usage only.
IMPORTANT NOTE
FCC Radiation Exposure Statement (for MAX HD2 IP67/ BR1/ Surf SOHO)
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance
20cm between the radiator & your body.
FCC Radiation Exposure Statement (for MAX HD2)
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance
35cm between the radiator & your body.
FCC Radiation Exposure Statement (for MAX 700)
Please add the following information (or something similar) that conveys the separation
distance for using up to four plug-in 3G USB devices.
a. 40cm minimum when the product is operated with one plug-in 3G USB device which
has maximum of 7W ERP output power.
b. 50cm minimum when the product is operated with two plug-in 3G USB devices which
have maximum of 7W ERP output power for each device.
c. 60cm minimum when the product is operated with three plug-in 3G USB devices
which have maximum of 7W ERP output power for each device.
d. 70cm minimum when the product is operated with four plug-in 3G USB devices which