User's Manual

USER MANUAL

Peplink Balance Series

Settings Upon

Connected

(e.g., LAN port IP address, DHCP server, etc.) when the Layer 2 VPN is connected.

Uncheck this option if the LAN IP address and gateway will use remote LAN settings.

Check this option if the LAN IP address and local DHCP server should remain unchanged

after the VPN is up.If you choose not to preserve LAN settings when the VPN is

connected, the device will not act as a router and most Layer 3 routing functions will cease

to work.

Configure

This setting specifies how a management IP address is acquired for the bridge port in the

specified VLAN (if defined) when the Layer 2 bridge is connected. Choosing As None will

result in no IP address being assigned to the bridge port for the Layer 2 connection.

- Advanced feature, please click the button on the top right hand corner to activate.

WAN Connection Priority

WAN Connection

Priority

These settings specify the priority of the WAN connections to be used in making VPN

bonding connections. A WAN connection will never be used when OFF is selected. Only

available WAN connections with the highest priority will be utilized.

To allow connection mapping to remote WANs. click the question mark icon found at the

top right of this section, and then click the displayed link to reveal the Connect to Remote

drop-down menu.

Send All Traffic To

This feature allows you to redirect all traffic to a specified PepVPN connection. Click the button to select your

connection and the following menu will appear:

You could also specify a DNS server to resolve incoming DNS requests