User's Manual

USER MANUAL

Peplink Balance Series

To enable Drop-in Mode, perform the following steps:

1. Check the Enable box under Drop-in Mode located at: Network > Interfaces > LAN. (After

checking the Enable box, most network settings for WAN1 will be hidden in theWeb Admin

Interface.)

2. Enterthe IP address of the WAN1 router in the WAN Default Gateway field. Ensure that the Peplink

Balance IP subnet is the same as the firewall’s WAN port and the router’s LAN port.

3. If there are hosts other than the router on the WAN segment of Peplink Balance, check theIhave

other host(s) on WAN segmentbox, enter the IP address(es) of the host(s), and then click the

down-arrow to add the hosts.

The following diagram illustrates: