User's Manual

USER MANUAL
Peplink Balance Series
http://www.peplink.com -189 / 227 - Copyright © 2014 Peplink
23.8 Configuration
Backing up the Peplink Balance settings immediately after the successful completion of the initial setup is
strongly recommended.
The functionality to download and upload Peplink Balance settings is found at:
System> Configuration
Configuration
Restore
Configuration to
Factory Settings
The Restore Factory Settings button is to reset the configuration to the factory default
settings. After clicking the button, you will need to click the Apply Changes button on the
top right corner to make the settings effective.
Downloading
Active
Configurations
The purpose of the Download button is to backup the current active settings. Click
Download and save the configuration file.
Uploading
Configurations
To restore or change settings based on a configuration file, click Choose File to locate the
configuration file on the local computer, and then click Upload.
The new settings can then be applied by clicking the Apply Changes button on the page
header, or you can cancel the procedure by pressing discard on the Main page of Web
Admin Interface.
Uploading
Configuration from
High Availability
Pair
(Available on Peplink Balance 210+)
In a High Availability (HA) configuration, the Balance unit can quickly load the configuration
of its HA counterpart. To do so, click the Upload button.
After loading the settings, configure the LAN IP address of the Peplink Balance unit to be
different from the HA counterpart.