User's Manual

USER MANUAL

Peplink Balance Series

To changea rule’s priority, simply drag and drop the rule:

· Holdthe left mouse button on the rule.

· Move it to the desired position.

· Drop it by releasing the mouse button.

To remove a rule, click the button.

Rules are matched from top to the bottom.If a connection matches any one of the upper rules, the

matching process will stop. If none of the rules match the connection, the Default rule will be applied.

The Default rule is Allow for both outbound and inbound access.

Tip

If the default inbound rule is set toAllow for NAT enabled WANs, no inbound Allow firewall rules will be required

for inbound Port Forwarding and inbound NAT Mapping rules. However, if the default inbound rule is set as

Deny, a corresponding Allow firewall rule will be required.