User's Manual

http://www.pepwave.com 7 Copyright @ 2013 Pepwave
5 Connecting to Web Admin Interface
1. Start a web browser on a computer that is connected with Pepwave Surf SOHO through LAN.
2. To connect to Web Admin Interface of Pepwave Surf SOHO, enter the following LAN IP address
in the address field of the web browser:
http://192.168.50.1
(This is the default LAN IP address of Pepwave Surf SOHO.)
3. Enter the following to access the Web
Admin Interface.
Username: admin
Password: admin
(This is the default Username and
Password of Pepwave Surf SOHO. The
Admin and Read-only User Password
can be changed at System > Admin
Security of the Web Admin Interface.)
Appendix A. Restoration of Factory Defaults
To restore the factory default settings on a Pepwave Surf SOHO unit, follow the steps below:
1. Locate the reset button on the rear panel of Pepwave Surf SOHO unit.
2. With a paper clip, press the reset button and hold it for at least 10 seconds until the unit reboots
itself.
After Pepwave Surf SOHO finishes rebooting, the factory default settings will be restored.
Important Note
All previous configurations and bandwidth usage data will be lost after restoring the factory default settings.
Regular backup of configuration settings is strongly recommended.