User Manual

USER MANUAL

Peplink Balance Series

4 Product Features

Peplink Balance Series products enable all LAN users to share broadband Internet connections, and

provide advanced features to enhance Internet access. The following is the list of supported features:

4.1 Supported Network Features

4.1.1 WAN

 Multiple public IP support (DHCP, PPPoE, Static IP Address, or GRE)

 10/100 Mbps Connection in Full/Half Duplex

 1000 Mbps Connection in Full/Half Duplex (Available on Peplink Balance 380+)

 USB Mobile Connection* (Available on Peplink Balance 20/30, 380+)

*Remark: Only one USB modem can be connected.

 Drop-in Mode on selectable WAN port with MAC address passthrough (Available on Peplink

Balance 210+)

 Network Address Translation (NAT) / Port Address Translation (PAT)

 Inbound and Outbound NAT mapping

 IPsec NAT-T and PPTP packet passthrough

 Multiple static IP addresses per WAN Connection

 MAC address clone

 Customizable MTU and MSS values

 WAN connection health check

 Dynamic DNS (Supported service providers: changeip.com, dyndns.org, no-ip.org and tzo.com)

4.1.2 LAN

 DHCP server on LAN

 Static routing rules

 Local DNS

4.1.3 VPN (Available on Peplink Balance 210+)

 Secure Site-to-Site VPN

 VPN load balancing and failover among selected WAN connections

 Site-to-Site VPN bandwidth bonding

 Ability to route Internet traffic to a remote VPN peer

 Optional pre-shared key setting

 Authenticate PPTP clients by RADIUS and LDAP servers (Available on Peplink Balance 380+)

 Site-to-Site VPN Throughput, Ping and Traceroute Test (Available on Peplink Balance

210+)PPTP server

 PPTP and IPsec passthrough

4.1.4 Inbound Traffic Management

 TCP/UDP traffic redirection to dedicated LAN server(s)

 Inbound link load balancing by means of DNS (Available on Peplink Balance 210+)

4.1.5 Outbound Policy

 Link load distribution per TCP/UDP service

 Persistent routing for specified source and/or destination IP addresses per TCP/UDP service

 Prioritize and route traffic to VPN tunnels with Priority and Enforced algorithms

4.1.6 WLAN Controller

• Configure and manage Pepwave AP devices

• Review the status of connected AP