User's Manual

http://www.pepwave.com
90
Copyright @ 2014 Pepwave
16 NAT Mappings
The configuration of NAT Mappings allows the IP address mapping of all inbound and outbound
NAT’dtraffic to and from an internal client IP address.
The settings to configure NAT Mappings are located at Advanced>NAT Mappings:
To add a rule for NAT Mappings, click Add NAT Rule, upon which the following screen will be displayed:
NAT Mapping Settings
LAN Client(s)
NAT Mapping rules can be defined for a single LAN IP Address, an IP Range, or an IP
Network.
Address
This refers to the LAN host’s private IP address. The system maps this address to a number
of public IP addresses, specified below, in order to facilitate inbound and outbound traffic.
This option is only available when IP Address is selected.
Range
The IP range is a contiguous group of private IP addresses used by the LAN host. The system
maps these addresses to a number of public IP addresses, specified below, to facilitate
outbound traffic.
This option is only available when IP Range is selected.