User's Manual

User Manual
Pepwave AP Pro
http://www.pepwave.com
26
Copyright ©
2011 Pepwave
9 Restoration of Factory Defaults
9.1 AP Pro
The following procedure restores the settings of Pepwave AP Pro device to factory defaults:
1. Power on the unit, wait for 1 minute until the Status LED turns green.
2. Press and hold the reset button on the rear panel for at least 5 seconds, then release.
3. The Status LED will blink, and then the unit will automatically reboot.
4. Wait for 1 minute or until the Status LED turns green, upon which the settings of Pepwave AP Pro
will have been restored to the factory defaults.
By default, the unit will acquire an IP address from a DHCP server.