User's Manual

User Manual
Pepwave AP Pro
http://www.pepwave.com
25
Copyright ©
2011 Pepwave
8 Commands
Upon selecting Commands from the navigation bar on the left-hand-side of the Main Menu, a list of
commands is displayed, as follows:
8.1 Activate Changes
Click on Activate Changes and a prompt will ask and confirm to save configuration and activate the AP
Pro unit.
8.2 Firmware
Commands - Firmware
Firmware Version
This shows the firmware version loaded into the flash partitions.
Flash Status
This shows the firmware status on the flash partitions.
Boot from
This indicates which flash partition boots up the system.
Firmware Upgrade
Target
This shows which flash partition is used for firmware upgrade.
Firmware Image File
Upload a firmware file for upgrading the unit’s software. A reboot is required
after upgrading the firmware.
8.3 Configuration
Commands - Configuration
Restore Factory
Default
This command is for restoring factory default settings of the AP Pro. Preserve
the network settings by checking the box next to Preserve Settings and select
Proceed. Settings including Server IP, Subnet Mask, Default Gateway, DNS
Server and Management VLAN ID will be preserved.
Download Active
Configuration To
File
Select this command to download the active configuration for backup
purposes.
Upload
Configuration File
Select this command to upload the configuration from a backed up
configuration file.
8.4 Misc
Commands - Misc
Download Debug
Information
Select this comment to download debugging information from the Pepwave AP
Pro unit.
In the event of technical issues, to facilitate prompt resolution by technical
support from Pepwave, please send along with a debug file with the support
request.
Reboot AP
This option is for rebooting the Pepwave AP Pro unit.
The Boot up firmware from Flash 1 or 2 can be selected and changed in here.