User's Manual

User Manual
Pepwave AP Pro
http://www.pepwave.com
22
Copyright ©
2011 Pepwave
7.4 WDS
Wireless Distributed System - WDS provides a way to link APs together when wired cabling is not
preferable. This also extends the wireless coverage of the wireless network for the wireless clients.
Click Add to add and configure a new WDS peer connection.
WDS Settings
Enable
This option enables this entry.
MAC Address
This setting gives the MAC address of the other AP to form a WDS link.
Security Policy
For more details, please refer to section 7.2.1.
7.5 SNMP
7.5.1 SNMP Settings
Upon selecting SNMP from the navigation bar on the left-hand-side of the Main Menu, the following page
is displayed to enable the configuration of SNMP server settings:
SNMP Settings
Server Name
This setting specifies the name that identifies the SNMP server.
SNMPv1
This setting specifies whether to enable or disable the support for Version 1 of
SNMP.
SNMPv2
This setting specifies whether to enable or disable the support for Version 2 of
SNMP.
SNMPv3
This setting specifies whether to enable or disable the support for Version 3 of
SNMP.
SNMP Trap
SNMP Trap is a message initiated from a client and sent to the AP Pro device.
Once this option is enabled, the following two options for SNMP Trap will be
available for configuration.
SNMP Trap
Receiver Name
This setting specifies the name that identifies the SNMP Trap Receiver.
SNMP Trap
IP Address
This setting specifies the IP address of the SNMP Trap Receiver.