User's Manual

User Manual
Pepwave AP Pro
http://www.pepwave.com
13
Copyright ©
2011 Pepwave
7.1.3 Manual Router Settings
Manual Router Settings will only be available when the AP Mode in the previous section had been
selected as Router mode. You can use the AP Pro as a DHCP server for other devices behind.
DHCP Server Parameters
LAN IP
This setting specifies the DHCP server IP address.
LAN Subnet Mask
This setting specifies the subnet mask of the DHCP server.
DHCP Server
Checked the box to enable the DHCP Server of this device. Following options
will be enabled once you have checked and enabled the service.
IP Start Range
This setting specifies the first address in the range of IP addresses to be
assigned to DHCP clients.
IP Stop Range
This setting specifies the last address in the range of IP addresses to be
assigned to DHCP clients.
Subnet Mask
This setting specifies the subnet mask to be used by DHCP clients.
Broadcast Address
This setting specifies the broadcast address to be used by DHCP clients.
Gateway
This setting specifies the default routing gateway to be used by DHCP clients.
DNS 1
This setting specifies the IP address of the primary DNS Server to be offered to
DHCP clients.
DNS 2
This setting specifies the IP address of the secondary DNS Server to be
offered to DHCP clients.
DNS 3
This setting specifies the IP address of the tertiary DNS Server to be offered to
DHCP clients.
Lease Time
This setting specifies the length of time throughout which an IP address of a
DHCP client remains valid. Upon expiration of the Lease Time, the assigned IP
address will no longer be valid and the renewal of the IP address assignment
will be required.
7.2 Wireless Networks
Upon selecting Wireless Networks under Configure section from the navigation bar on the left, the
following shows the configured SSID available on the system:
General Wireless Networks Settings
Wireless Network
SSID
The SSID of the virtual Access Point (AP).
Security Policy
Shows the configured wireless authentication and encryption methods.
Default VLAN ID
This setting specifies the VLAN ID to be tagged on all outgoing packets
generated from the virtual AP (i.e. packets that travel from the Wi-Fi segment,
through the Pepwave AP Pro unit to Ethernet segment via the LAN port).
If 802.1x is enabled, a per-user VLAN ID can be specified in the authentication
reply from the Radius server. If it is set, the value specified via Default VLAN
ID will be overridden.
Status
Shows whether the virtual AP is enabled or disabled.