User's Manual

User Manual
Pepwave AP Pro
http://www.pepwave.com
11
Copyright ©
2011 Pepwave
7 Configuration
7.1 System
Upon selecting System under Configure section from the navigation bar on the left, the following page
shows the configuration options:
7.1.1 Basic
System Settings - Basic
AP Name
A user-specified name for this access point.
This value can be retrieved via SNMP.
Location
A user-specified name for the location of the access point.
This value can be retrieved via SNMP.
Timezone
This option specifies the time region to be used for representing the time on
the system.
Domain Name
Domain name can be set for wireless clients to have a readable name for the
web management.
Keep Default IP With this option disabled, default IP 192.168.0.3 of the device will be disabled.
IP Address Mode
The options are Automatic and Manual.
Automatic: IP address of the Pepwave AP Pro unit is acquired from a DHCP
server on the Ethernet segment.
Manual: A user-specified IP address is used.
IP Address Mode – Manual
Static IP Address
This specifies the unique IP address for the Pepwave AP Pro unit to
communicate on the Ethernet segment.
This IP address is distinct from the admin IP address 192.168.0.3 on the
Ethernet segment.
Subnet Mask
This setting specifies the subnet mask of the Pepwave AP Pro unit.
Default Gateway
This setting specifies the default gateway of the Pepwave AP Pro unit.
DNS Server
This is the DNS server address to be used by the Pepwave AP Pro unit for
resolving host names.
IP Address Mode – PPPoE
PPPoE Username
This specifies the username required in order to connect via PPPoE to acquire
Internet connectivity. The information is typically determined by and can be
obtained from the ISP.
PPPoE Password
This specifies the password required in order to connect via PPPoE to acquire
Internet connectivity. The information is typically determined by and can be
obtained from the ISP.
PPPoE Service
Name
This is a PPPoE parameter which is provided by the ISP.
Note: Leave this field empty if you are not sure.