User's Manual

User Manual
http://www.pepwave.com
16
Copyright ©
2011
Pepwave
7.2 Wireless Networks
Upon selecting Wireless Networks under Configure section from the navigation bar on the left, the
following shows the configured SSID available on the system:
General Wireless Networks Settings
Wireless Network
SSID
The SSID of the virtual Access Point (AP).
Security Policy
Shows the configured wireless authentication and encryption methods.
Default VLAN ID
This setting specifies the VLAN ID to be tagged on all outgoing packets
generated from the virtual AP (i.e. packets that travel from the Wi-Fi segment,
through the Pepwave AP One unit to Ethernet segment via the LAN port).
If 802.1x is enabled, a per-user VLAN ID can be specified in the authentication
reply from the Radius server. If it is set, the value specified via Default VLAN
ID will be overridden.
Status
Shows whether the virtual AP is enabled or disabled.
MAC Address
(BSSID)
Shows the detailed BSSIDs.
Portal
Shows if the InControl Guest Portal is enabled. Please refer to section 7.2.2 for
details.
To add a new virtual AP, click the Add button. To modify the settings for a virtual AP, click the link Edit on
the right of the desired WLAN SSID, upon which the following Wireless Network Details is displayed.
Click on the Info link to check the following networking statistics: Broadcast SSID, MAC Filter,
Bandwidth Control, Layer 2 Isolation.
General Wireless Networks Settings – Info
Broadcast SSID
This shows if the Broadcast SSID feature of this network is enabled.
MAC Filter
This shows if the MAC Filter feature of this network is enabled.
Bandwidth Control
This shows if the Bandwidth Control feature of this network is enabled.
Layer 2 Isolation
This shows if the Layer 2 Isolation feature of this network is enabled.