User's Manual

User Manual
http://www.pepwave.com
15
Copyright ©
2011
Pepwave
7.1.3 Manual Router Settings
Manual Router Settings will only be available when the AP Mode in the previous section had been
selected as Router mode. You can use the AP One as a DHCP server for other devices behind.
DHCP Server Parameters
LAN IP
This setting specifies the DHCP server IP address.
LAN Subnet Mask
This setting specifies the subnet mask of the DHCP server.
DHCP Server
Checked the box to enable the DHCP Server of this device. Following options
will be enabled once you have checked and enabled the service.
IP Start Range
This setting specifies the first address in the range of IP addresses to be
assigned to DHCP clients.
IP Stop Range
This setting specifies the last address in the range of IP addresses to be
assigned to DHCP clients.
Subnet Mask
This setting specifies the subnet mask to be used by DHCP clients.
Broadcast Address
This setting specifies the broadcast address to be used by DHCP clients.
Gateway
This setting specifies the default routing gateway to be used by DHCP clients.
DNS 1
This setting specifies the IP address of the primary DNS Server to be offered to
DHCP clients.
DNS 2
This setting specifies the IP address of the secondary DNS Server to be
offered to DHCP clients.
DNS 3
This setting specifies the IP address of the tertiary DNS Server to be offered to
DHCP clients.
Lease Time
This setting specifies the length of time throughout which an IP address of a
DHCP client remains valid. Upon expiration of the Lease Time, the assigned IP
address will no longer be valid and the renewal of the IP address assignment
will be required.