User's Manual

User Manual
http://www.pepwave.com
14
Copyright ©
2011
Pepwave
Subnet Mask
This setting specifies the subnet mask of the Pepwave AP One unit.
Default Gateway
This setting specifies the default gateway of the Pepwave AP One unit.
DNS Server
This is the DNS server address to be used by the Pepwave AP One unit for
resolving host names.
IP Address Mode – PPPoE
PPPoE Username
This specifies the username required in order to connect via PPPoE to acquire
Internet connectivity. The information is typically determined by and can be
obtained from the ISP.
PPPoE Password
This specifies the password required in order to connect via PPPoE to acquire
Internet connectivity. The information is typically determined by and can be
obtained from the ISP.
PPPoE Service
Name
This is a PPPoE parameter which is provided by the ISP.
Note: Leave this field empty if you are not sure.
7.1.2 Advanced
System Settings - Advanced
Management VLAN
ID
This specifies the VLAN from which management sessions are allowed. The
establishment of management sessions is restricted only to the specified VLAN
ID. If Management VLAN ID is set to zero, no VLAN restriction is applied.
The default value of this setting is zero. It means no tagging is enabled
(instead of tagged with zero).
NTP Server
This is the Network Time Protocol (NTP) Server hostname to be used for
synchronizing system clock of Pepwave AP One.
The default value of this setting is pool.ntp.org.
Scheduled Reboot
The system would perform reboot based on the scheduled time set. Click the
box above the Schedule to Enable this feature.
Ethernet
Speed/Duplex
This setting provides the option to set the speed of the Ethernet.
AP Mode
Available options are Bridge and Router. With this option set as Router, the
following Manual Router Settings will be available.