User's Manual
Table Of Contents
- User Manual
- Table of Contents
- 1 Copyright
- 2 Disclaimer
- 3 Product Description
- 4 Using the Pepwave Devices
- 5 CPE Settings Details
- 6 Port Forwarding
- 7 QoS
- 8 Firmware Upgrade
- 9 Debug and System information
- 10 Restore to Default Settings
- Appendix
- Table of Contents
http://www.pepwave.com 30 Copyright © 2011 Pepwave
User Manual
Pepwave PolePoint Series
10 Restore to Default Settings
10.1 Surf Indoor Series
There are two ways to restore the Pepwave Surf Indoor unit to default settings.
If you are able to access the web admin interface, go to the CPE Setup page, and click the Restore and
Reboot button.
Otherwise, you can also power up the unit and wait for about 1 min. Then press the Reset Button at the
rear side of the unit using a pin and then hold it for 5 seconds. The unit will restore the settings to factory
default and reboot.
10.2 Surf DX Series
There are two ways to restore the Pepwave Surf DX to default settings.
If you are able to access the web admin interface, go to the CPE Setup page, and click the Restore and
Reboot button.
Otherwise, you can also power up the Surf DX unit and wait for about 1 min. Then push the Reset Button
at the panel side of the unit and then hold it for 5 seconds. The unit will restore the settings to factory
default and reboot.
Reset
Button