User's Manual

http://www.pepwave.com 21 Copyright © 2011 Pepwave
User Manual
Pepwave PolePoint Series
5.7 Integrated Wi-Fi Access Point Configuration
Integrated Wi-Fi Access Point is configured via the CPE Setup tab. The following sections will provide
information as a guide through the configuration.
The available Access Point (AP) settings for the Integrated Wi-Fi Access Point functionality are as follows:
 Disable
Integrated Wi-Fi Access Point functionality is disabled.
 Configure Manually
Manual configuration of the SSID, Authentication, and Encryption Key values corresponding to
the Access Point.
 Configure Automatically
The SSID, Authentication, and Encryption Key values corresponding to the Access Point are
automatically configured to be the same as the respective values that correspond to the ISP’s
network.
5.7.1 Access Point Settings
AP Settings
Keep AP
With this option enabled, the Wi-Fi Access Point will always on even if there is
no connection to the Internet connection source.
AP Transmit Power
Adjustment
An option to retain a lower power setting for indoor home devices. Available
options depend on the radio power of the device.
Broadcast SSID
With this option enabled, the configured SSID will be broadcast such that it can
be detected by an SSID scan. Otherwise, the configured SSID will not be
broadcast such that it cannot be detected by an SSID scan. In order to connect
with the access point, the SSID needs to be known by the client.
Client Isolation
Prevent wireless clients connected to the AP from communicating with each
other.