User's Manual

Page 3 of 4
As long as 2 conditions above are met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional
compliance requirement with this module installed (for example, digital device emission, PC peripheral requirements, etc.)
2.7Antennas
Check: see manual on page 10 below key points:
Pls include Antenna type and gain used in manual.
Antenna Type
Brand/
manufacturer
Model No.
Max.
Antenna
Gain
PCB antenna
B
rand: PEPXIM
;
PEPWAVE
;
peplink
Manufacturer:
PISMO LABS TECHNOLOGY LIMITED
P013 antenna
5dBi
Antenna Change Notice to Host manufacturer
If you desire to increase antenna gain and either change antenna type or use same antenna type certified, a Class II permissive change application is required to be filed by
us, or you (host manufacturer) can take responsibility through the change in FCC ID (new application) procedure followed by a Class II permissive change application.
2.8 Label and compliance information
Check: see manual on page 11 below key points:
FCC: The final end product must be labeled in a visible area with the following: ”Contains FCC ID: U8G-P1013”.The equipment complies with FCC RF exposure limits set forth for an
uncontrolled environment. The equipment must not be co-located or operating in conjunction with any other antenna or transmitter.
IC: The final end product must be labeled in a visible area with the following: ”Contains IC ID: 20682- P1013”.The equipment complies with FCC RF exposure limits set forth for an uncontrolled
environment. The equipment must not be co-located or operating in conjunction with any other antenna or transmitter.