User's Manual

Page 2 of 4
OEM Integration Instructions：
This device is intended only for OEM integrators under the following conditions：
The module can be used to installation in other host. the transmitter module may not be colocated with any other transmit or antenna.
The module shall be only used with the integral antenna(s) that has been originally tested and certified with this module.
As long as 2 conditions above are met, further transmitter test will not be required.However, the OEM integrator is still responsible for testing their end-product for any additional
compliance requirement with this module installed (for example, digital device emission, PC peripheral requirements, etc.)
2.4 Limited module procedures
Not applicable.
2.5 Trace antenna designs
Not applicable.
2.6 RF exposure considerations
Check: see manual on page 8; 11 below key points:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a
minimum distance of 20cm between the radiator and your body.
OEM Integration Instructions：
This device is intended only for OEM integrators under the following conditions：
The module can be used to installation in other host. the transmitter module may not be collocated with any other transmit or antenna.
The module shall be only used with the integral antenna(s) that has been originally tested and certified with this module.