Assembly Instructions

ManualsBrandsPirelli ManualsAutomotiveTPMS (Tire Pressure Monitoring System)

SAFETY AND REGULATORY INFORMATION

Safety messages

General Safety Warnings

Cyber Fleet Sensor Node (CFSN) sensor (hereinafter referred to as the Sensor), a

radio device equipped with a lithium battery which is neither replaceable nor

rechargeable.

When used in the tyre, the specified conditions of use for the tyre itself must be

respected. The safety and regulatory information for the Sensor is given below.

Regulatory Information - FCC

Sensor Name: Pirelli CyberTM Fleet Sensor Node.

Model Name CFSN-15S

FCC ID: 2ANX7CFSN1

Compliance with Part 15 of the FCC Rules

The equipment complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

i. The equipment may not cause harmful interference, and

ii. The equipment must accept any interference received, including

interference that may cause undesired operation.

Compliance with Class B digital devices

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the User is encouraged to try to correct the

interference by one of the following measures:

iii. Reorient or relocate the receiving antenna.

iv. Increase the separation between the equipment and receiver.

v. Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

vi. Consult the dealer or an experienced radio/TV technician for help.

FCC Caution

i. Any changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate this equipment.

ii. Co-location of this transmitter with other transmitters that operate simultaneously

are required to be evaluated using the FCC multi-transmitter procedures.

Radiation Exposure

This equipment complies with portable FCC radio frequency exposure limits set forth

for an uncontrolled environment.

Wireless Interface

The Sensor is a radio device with wireless interface.

The Sensor is equipped with a Bluetooth® interface which operates in the 2.4 GHz ISM

band. (2.4000 - 2.4835 GHz). It meets the requirements for low-energy Bluetooth® modules

which support Bluetooth® Low Energy (BLE) 4.2.

Battery

WARNING

Improper use of the tyres and the Sensors can cause harm to human

health and the environment.

Disassembly of the Sensor and its battery by the user is prohibited.

The lithium batteries inside the Sensors contain flammable material.

The substances contained in the battery are harmful and can have a

negative impact on human health and the environment.

Improper use of lithium batteries can cause overheating which could lead to

a fire or explosion, with the risk of personal injury and/or environmental

damage. To avoid such incidents during use/handling of the batteries,

ensure you observe the following precautions:

 Do not dispose of the batteries in fire

 Do not heat the batteries or expose them to sources of heat.

 Do not disassemble the batteries.

In the event of improper use of and/or accidental damage to the battery,

which causes the contents to leak out, follow the precautions outlined

below.

 Inhalation: the fumes can cause respiratory irritation; leave the area

and go to a cool and well-ventilated location.

 Contact with skin: wash immediately with plenty of water and

seek medical attention, particularly if any irritation persists.

 Contact with eyes: wash immediately with plenty of water for at least 15

minutes.

 Contact with mouth: rinse immediately with plenty of water and seek

medical attention.

In the event of a fault with the sensor and possible accidental damage to the

battery, which causes the contents to leak out, tyre dealers are recommended

to use appropriate personal protective equipment (PPE) when removing the

device in order to avoid the issues outlined above.

Waste Sorting and Recycling of the Sensors

It is the installer's responsibility to dispose of the Sensors in accordance with applicable

legislation. Incorrect disposal of materials can lead to penalties in accordance with

applicable legislation.

Separating waste and recycling contributes to the preservation of natural

resources and ensures correct recovery of materials, helping protect human

health and the environment.

Sensors on worn tyres must be removed from the tyre and disposed of

in accordance with applicable legislation.

For further information on the methods and locations for disposing of used

Sensors, contact Pirelli support at www.pirellicyberfleet.com.

Disposal requirements

The crossed-out wheelie bin symbol on the Sensors and their packaging

indicates that the Sensors and the batteries contained in them must be

disposed of separately, and NOT with unsorted urban waste.

Pirelli Tire LLC

100 Pirelli Drive, Rome, GA 30161-7000 – USA

WARNING Indicates a hazardous situation which, if not avoided, may

cause death or serious injury.