Manual

TROUBLESHOOTING
WARNING
DO NOT ATTEMPT TO PERFORM MAINTENANCE PROCEDURES UNLESS QUALIFIED TO DO SO.
CONTACT PMI INC., FOR REPAIR ASSISTANCE AND INFORMATION REGARDING AUTHORIZED PMI PIRANHA™
REPAIR FACILITIES. PHONE [phone] /BUYPMI.COM
BEFORE DISASSEMBLY OF THE MARKER, REMOVE POWER SOURCE; REMOVE ALL PAINTBALLS FROM THE
MARKER, BARREL, AND LOADER.
PAINTBALL MARKER POWER SYSTEMS MUST BE REPAIRED OR REPLACED WITH THE CORRECT PRESSURE
RATED COMPONENTS.
SHOOT ONLY QUALITY PAINTBALLS. PMI PREMIUM, PMI GOLD TWO-TONE™, PMI EL TIGRE™, PMI ALL STAR™
AND MARBALLIZER™ PAINTBALLS ARE RECOMMENDED FOR USE IN THE PMI PIRANHA™
Barrel comes loose Check barrel o-ring; firmly tighten barrel
Do not over oil barrel o-ring
PAINTBALLS
Check for broken paint or oil in barrel, loader, feed
tube and chamber. Bolt/ hammer assembly area must
also be free of broken paint. Check that marker is
not shooting over 300 fps. Disassemble and clean.
Not flying straight
Check ball retainer (20) and replace if necessary. Check
that velocity does not exceed 300 fps.
Break in Barrel
Do not drop into feed tube
Shake loader; check loader and feed tube
for broken paint
Two shoot at a time
Check ball retainer (20) and replace if
necessary
Check to see that the threads on the barrel match, if it
is difficult to tighten the threads onto the receiver; if
threading is mismatched, barrel is not designed for use
with PMI Piranha™.
Aftermarket barrel does not tighten
BARREL
PMI Piranha™34