Manual

WARNING
DO NOT ATTEMPT TO PERFORM MAINTENANCE PROCEDURES UNLESS QUALIFIED TO DO SO.
THIS TROUBLESHOOTING GUIDE DOES NOT COVER ALL SITUATIONS AN INDIVIDUAL MAY ENCOUNTER.
CONTACT PMI, INC., FOR REPAIR ASSISTANCE AND INFORMATION REGARDING AUTHORIZED PMI PIRANHA™
REPAIR FACILITIES. PHONE [phone] / BUYPMI.COM
PAINTBALL MARKER POWER SYSTEMS MUST BE REPAIRED OR REPLACED WITH THE CORRECT PRESSURE
RATED COMPONENTS.
BEFORE DISASSEMBLY OF THE MARKER, REMOVE POWER SOURCE; REMOVE ALL PAINTBALLS FROM THE
MARKER, BARREL, AND LOADER.
Leaks down barrel Check cup seal for wear or grooves. Replace.
Leaks at connection between braided air hose Requires disassembly of air hose assembly
. and fitting for repairs; contact factory or factory
authorized repair center
Leaks at body of marker or heavily down the barrel Requires removal of valve and inspection
of valve o-rings, cup seal, and valve surface.
Never use a screwdriver or metal object to
remove valve. Use a pencil eraser or other
soft instrument.
Leaks at connection between gas-through foregrip Remove foregrip unit and check o-rings.
& vertical ASA Replace with tank o-rings if worn or broken.
Leak in pressure source between tank valve Do not fill cylinder. Immediately take to
and cylinder qualified personnel for inspection. Cylinder
must be drained
Leaks at connection between ASA and tank Check o-ring at connection or on remote hose
connector
AIR LEAK
PMI Piranha™32
TROUBLESHOOTING