Manual

4. To remove the ASA adapter, remove the small allen screw under the receiver. Figure 42. The ASA adapter
can then be removed. Figure 43. NOTE: The o-ring on the ASA adapter that, at insertion, contacts the
receiver first is white. The other o-ring is black.
The valve body must be inserted correctly: note that the hole to the rear of the valve is tapered, and has a
black o-ring. The front of the valve has a larger hole, is not tapered, and has a white polyurethane o-ring. Be
careful reinserting valve body. Any scratches to the front can cause leaks. The valve pin assembly must be
inserted correctly; valve pin must drop down into valve body completely.Valve spring must be centered in bore.
IMPORTANT: Valve body o-rings and front valve portion of the receiver must
be well oiled prior to valve body insertion.
6. Follow the procedures in this manual for adding power system, loader, and paintballs.
Questions about the operation of the PMI Piranha™ paintball marker may be directed to: Pursuit Marketing,
Inc., 500 East Touhy Ave., Unit C, Des Plaines, IL. 60018 USA ; phone [phone] or buypmi.com for any
updates regarding your Piranha™ purchase.
Figure 44 Figure 45 Figure 46
Figure 42
Figure 43
5. To access the valve assembly,
remove the valve spring, pin, and
guide as in Figure 44. Remove
the small brass screw located in
the center of the underside of
the receiver, Figure 45. To remove
or reinsert the valve body, use a
flat ended wooden dowel or the
eraser end of a pencil to push
the valve body out of the front
of the r e c e i v e r , Figure 46.
PMI Piranha™29