Manual

The PMI Piranha™ is easy to strip for cleaning and basic maintenance. Regular cleaning
and maintenance is highly recommended, including frequent checks of
all power system components. Keep screws tightened. Replace worn components with
factory parts; all leaks must be repaired promptly. Power system repairs are best performed by the
factory or an authorized factory repair facility; contact PMI for information regarding authorized PMI
Piranha™ repair facilities.
WARNING
DO NOT ATTEMPT TO PERFORM MAINTENANCE PROCEDURES UNLESS QUALIFIED TO DO SO. DO NOT
DISASSEMBLE MARKER UNTIL IT IS COMPLETELY DRAINED OF COMPRESSED GAS OR AIR AND ALL
PAINTBALLS HAVE BEEN REMOVED. ALL FILLING OF COMPRESSED GAS OR AIR CYLINDERS MUST BE
DONE BY QUALIFIED PERSONS.
CONTACT PMI, INC., FOR REPAIR ASSISTANCE AND INFORMATION REGARDING AUTHORIZED PMI
PIRANHA™ REPAIR FACILITIES. PHONE [phone];WWW. BUYPMI.COM
PAINTBALL MARKER POWER SYSTEMS MUST BE REPAIRED OR REPLACED ONLY WITH THE CORRECT
PRESSURE RATED COMPONENTS.
DISASSEMBLY PROCEDURE
1. Before disassembly of the marker, first remove the air tank, and then remove all paintballs from
the marker, barrel, and loader.
2. Leave barrel plug firmly inserted in
barrel and keep barrel pointed in a
safe direction.
3. To remove the bolt/hammer assembly,
first remove the field strip pin. Figure
10 The field strip pin is at the
center rear of the receiver and is
removed by pulling it out of the left
side of the marker.
Figure 10 Remove field strip pin to begin disassembly.
DISASSEMBLY
PMI Piranha™23