Quick Assembly Guide

Once the wheel is in place and ght, turn the bike the right way up

and squeeze the brake arms together unl there is a 1 - 1.5 mm

gap betwen the brake pads and the rim. Both sides should be

equal. Whilst holding in place you then need to pull the brake

cable ght, and ghten the cable pinch bolt by turning clockwise

using the spanner provided as shown.

Place the pointed side of the locking washer into the

hole on the fork. Make sure the gap between the

wheel and the fork is equal on both sides.

Tighten the nut with the spanner provided.

THE PIN ON THE LOCKING

WASHER MUST BE PLACED

IN THE HOLE.

Locking washers must be posioned correctly in this step:

CORRECT BRAKE & WHEEL FITTING IS VERY IMPORTANT FOR YOUR SAFETY

IF YOU HAVE ANY PROBLEMS THERE IS MORE INFORMATION IN THE USER MANUAL

FAILURE TO CORRECTLY SET THE BRAKES MAY RESULT IN SERIOUS INJURY

IF YOU ARE EXPERIENCING ANY PROBLEMS PLEASE CALL 0161 813 1745 BEFORE RETURNING BIKE TO STORE