Quick Assembly Guide

6
A
You will need to release your caliper brakes to
install or replace a wheel, slightly loosen the cable
pinch bolt. Turn it an-clockwise with the spanner
provided as shown. This will open up the break
pads so the wheel fits through.
3.- FITTING THE FRONT WHEEL
B
Turn the bike upside down. Loosen the nuts on the
front wheel axle by turning an-clockwise - you
need enough thread showing on the axle so the
wheel slots easily onto the fork. Make sure the
locking washers are on the outside of the fork as
shown.
TOOLS NEEDED
SPANNER
i ii
LOCKING
WASHER
NUTS
AXLE
FORK
IF YOU ARE EXPERIENCING ANY PROBLEMS PLEASE CALL 0161 813 1745 BEFORE RETURNING BIKE TO STORE