Manual

TROUBLESHOOTING
TROUBLESHOOTING
21
22
Leaks at connection between braided air hose Requires disassembly of air hose assembly for repairs;
and fitting contact factory or factory authorized repair center.
Leaks down barrel Check front of cup seal where it touches the valve
for any wear or grooves. Replace if leak continues.
Leaks at body of marker or heavily down Requires removal of valve and inspection
the barrel of front valve O-ring (can be replaced with
bottle O-rings), cup seal and valve surface where
the cup seal touches the valve. A valve installed
backwards will cause a leak. Never use a screw
driver or metal object to remove or install a
valve body. Use a pencil eraser or other soft
instrument.
Leaks at connection between gas-through Remove foregrip unit and check O-rings
foregrip & vertical ASA Replace with tank O-rings if worn or broken.
Leak in pressure source between tank valve Do not fill cylinder. Immediately take to qualified
and cylinder personnel for inspection. Cylinder must be drained.
Leaks at connection between ASA and tank Check tank O-ring at connection or on remote
hose connector. See page 24.
AIR LEAK
Trigger pulls back, marker will not shoot Check that the safety slide is back and the
red dot is visible. Check that the marker is
cocked, air source is correctly attached and air
source is properly filled. If the frame is
electronic, make sure battery is properly charged
and the trigger frame screws are tight.
Trigger action does not feel smooth Check pin at top of trigger. Use center punch to
tap pin back into place.
Marker runs on (partially cycles more than Check that air source is correctly attached to
once when trigger is squeezed) marker. Check that air source is adequately filled.
Check sear and Blue Hammer O-ring for wear.
VELOCITY
Low Check that air source is adequately filled
Low Adjust velocity adjuster clockwise
Low Remove bolt/hammer assembly and clean it;
clean inside receiver area where bolt/hammer
assembly is located; lubricate all O-rings on bolt
assembly with synthetic paintball marker oil
Low Change to a stiffer hammer spring
High Adjust velocity adjuster counterclockwise
High Change to a softer hammer spring
(
DO NOT EXCEED 300 FEET-PER-SECOND)
Safety Fails Take off the left gripframe panel and see
if the safety spring (#48) and safety ball (#47)
are still in their groove. If they are absent, call
KEE immediately.
TRIGGER AND SHOOTING
Marker shoots but does not recock Check Blue Hammer O-ring for wear and replace
Blue Hammer O-ring (#35) if needed, using
factory O-ring only. A tank O-ring will not work.
Using anything other than a factory Blue Hammer
O-ring can cause run on. Make sure marker is
properly oiled.
Manual_Piranha_5.5_eng.qxd 11/16/07 1:57 PM Page 16