Manual

DISASSEMBLY
10
SPRING KIT INSTRUCTIONS
1. Never allow the marker to shoot at velocities exceeding 300 FPS.
2. Always remove the gas source and all paintballs from your marker before you disassemble any part of it.
3. Before changing any component of a paintball marker, fully understand the entire operator’s manual.
4. When changing springs or anything else that will alter shooting velocity of the marker, have
appropriate chronograph available for testing results.
5. Never shoot marker at the heads of people or animals. Never shoot at anyone not wearing goggles
and head protection approved for paintball games.
6. Spring tension in order from strongest to weakest–red, blue, then white.
SAFETY FIRST!
Use a Barrel Plug!
SEE PAGE 17 FOR DISASSEMBLY OR REASSEMBLY INSTRUCTIONS
Action:
Paintballs:
Safety:
Barrel Length:
Action:Barrel:
Height:
Length:
Air Source:
Grip:
Tournament grade semi-automatic powered by either N
2
or CO
2
9 inches
Threaded and polished aluminum; ported for all models
8.5 inches (without attached loader):
17.5 inches overall (with 9 in. barrel and without attachments)
Input Pressure:
Operating Pressure:
Air Source Input:
Mechanical slide
For use only with standard “.68 caliber” (.68-inch diameter)
paintballs. RPS paintballs recommended
Accepts standard connections for CO2, regulated N2, or regulated
compressed air
Recommended 650 psi to 1000 psi
Not to exceed 1000 psi
Bottomline ASA accepts standard paintball threading
Durable space age polymer with double trigger & guard
The Piranha
®
is easy to strip for cleaning and basic maintenance. Regular cleaning and maintenance
is highly recommended. Keep screws tightened. Replace worn components with factory parts; all leaks must
be repaired promptly. Air system repairs are best performed by the factory or an authorized factory repair facility.
Contact KEE for information regarding authorized Piranha
®
repair facilities.
9
SPECIFICATIONS
DISASSEMBLY PROCEDURE
1. Before disassembling the marker, first remove the air tank, and then remove all paintballs from
the marker, barrel, and loader.
Figure 8. Remove field strip pin to
begin disassembly.
WWAA RR NN II NN GG
DO NOT ATTEMPT TO PERFORM MAINTENANCE PROCEDURES UNLESS QUALIFIED TO DO SO. DO
NOT DISASSEMBLE MARKER UNTIL IT IS COMPLETELY DRAINED OF COMPRESSED GAS OR AIR AND
ALL PAINTBALLS HAVE BEEN REMOVED. ALL FILLING OF COMPRESSED GAS OR AIR CYLINDERS MUST
BE DONE BY QUALIFIED PERSONS.
CONTACT KEE FOR REPAIR ASSISTANCE AND INFORMATION REGARDING AUTHORIZED PIRANHA
®
REPAIR FACILITIES. PHONE [phone]; KEEACTIONSPORTS.COM
THE PAINTBALL MARKER AIR SYSTEM MUST BE REPAIRED OR REPLACED ONLY WITH THE CORRECT
PRESSURE RATED COMPONENTS.
2. Leave barrel plug firmly inserted in barrel and keep
barrel pointed in a safe direction.
3. To remove the bolt/hammer assembly, first remove the
field strip pin. See Figure 8. The field strip pin is at the
center rear of the receiver and is removed by pulling it
out of the left side of the marker.
4. Grasp the block assembly and slowly begin to pull the bolt/hammer assembly out of the marker. See Fig. 9.
5. When the bolt/hammer assembly is about halfway out, grasp it with one hand and continue to hold it
intact while removing it completely from the marker. See Figure 10.
Figure 11 Bolt-hammer assembly
removed.
Figure 9
Figure 10 Grasp assembly.
Oil Here
Oil Here
Manual_Piranha_5.5_eng.qxd 11/16/07 1:57 PM Page 10