Operator's Manual

TOP 6 QUESTIONS ANSWERED
1. Leaks down barrel Make sure marker is cocked before attaching air.
Check cup seal for wear or grooves. Replace if
leak continues. See page 13 for more information.
2. Low velocity (to make it shoot harder) 1. Check that air source is adequately filled.
2. Adjust velocity by turning the velocity adjusting
screw clockwise.
3. Remove bolt/hammer assembly and clean it.
Clean inside receiver area where bolt/hammer
assembly is located. Lubricate all O-rings
on bolt assembly with synthetic paintball
marker oil.
4. Change to a stiffer hammer spring.
See page 8 for complete velocity instructions.
3. Before you change any O-ring Do not replace the Blue Hammer O-ring with a bottle
or “seal” O-ring! The marker needs a Piranha
®
Blue Hammer
O-ring to work properly.
4. Regular Maintenance See page 11.
5. What is the “sear release slide?” The sear release slide is a mechanical slide that
allows you to re-install your bolt/block/hammer assembly
back into your marker without shooting the marker or
taking off the grip frame. See Reassembly Procedure on
page 11 for more information.
6. Marker doesn’t work out of the box? 1. Is tank filled? All tanks sent through the mail
come empty.
2. Is the marker cocked? Always cock marker before
airing it up
3. Is safety “off”?
4. Call us at 1.800.724.6822.
3
Manual_Piranha_6.0_eng_fr_sp.qxp 2/6/08 5:02 PM Page 4