Operator's Manual

WARRANTY
19
vary from state to state.
KEE is not liable for any consequential damages or incidental damages which may arise from the use or
operation of the Piranha
®
or from any breach of the warranty herein set forth.
WARRANTY REGISTRATION FORM
Please fill out entirely the enclosed Piranha
®
Registration form and mail it to: KEE Action Sports, 570 Mantua
Blvd., Sewell, NJ 08080 USA.
The Piranha
®
is a registered trademark. Design rights & all rights reserved. All patterns, drawings, photo-
graphs, instructions or manuals remain the intellectual property of the manufacturer. Patents
pending. All rights will be strictly enforced.
The Piranha
®
GTI Plus is capable of high rates-of-fire. An agitating hopper such as an
Extreme Rage
®
Overdrive
™
is recommended for better performance.
Cocking Rod
Velocity
Adjustment
Screw
Safety Slide
Sear Release
Gas Thru Grip
High Performance Barrel
Bottomline Adapter
Dual Ball Detents
OPERATING THE PIRANHA
®
GTI PLUS: 1. Attach threaded
barrel firmly to marker. 2. At this time, do not attach air source or loader
and do not load paintballs into marker. 3. Insert barrel plug firmly into bar-
rel. 4. Pull the cocking knob straight back from the rear of the marker until
the cocking mechanism locks back in the cocked position. Always cock mark-
er before airing it up. During cocking the flush cocking rod will recoil or
“spring back” into the marker once released and will only move slightly dur-
ing marker operation. 5. Slide safety “off,” 6. Squeeze the trigger with an
even pressure. You should hear the hammer and bolt assembly slide forward.
7. Cock the marker. 8. Before attaching the air source, read and understand
the section in the manual on “Compressed Gas/Air.” Follow safety rules for
handling compressed gas/air. If any leak occurs in the marker, refer to trou-
bleshooting guide or to a qualified airsmith. Use only cylinders for com-
pressed gas or air that comply with all applicable laws and regulations,
including but not limited to those of the U.S. Department of Transportation,
OSHA, Compressed Gas Association, and/or American Society for Testing and
Materials. 9. With goggles on, test for function after attaching air source:
Squeeze the trigger. The marker should shoot air and the cocking knob
should cycle slightly after each trigger squeeze, repeat several times. Flush
cocking rods will bobble some, but they will not come out all the way.
10. Slide safety forward (semi version). Paintballs may then be loaded.
Manual_Piranha_6.0_eng_fr_sp.qxp 2/6/08 5:03 PM Page 20