Operator's Manual

CUP SEAL & VALVE REMOVAL
13
Figure 27
Figure 28
1/8"
Allen
Screw
1/8" Allen Screw
BottomLine
ASA
WWAA RR NN II NN GG
DO NOT ATTEMPT TO COMPLETELY DISASSEMBLE YOUR PIRANHA
®
UNLESS QUALIFIED TO DO SO.
CONTACT KEE FOR REPAIR ASSISTANCE AND INFORMATION REGARDING AUTHORIZED KEE
PIRANHA
®
REPAIR FACILITIES. PHONE: [phone] WEB: KEEACTIONSPORTS.COM
THE PAINTBALL MARKER AIR SYSTEM MUST BE REPAIRED OR REPLACED ONLY WITH THE CORRECT
PRESSURE RATED COMPONENTS.
3. To remove the bottom line air system, detach the bottom line ASA from the grip by removing the two
screws (#42). See Figure 27. The 5/32” allen wrench for this procedure is not included with the marker.
Then unscrew the vertical grip (#40) or regulator.
5. To access the valve, use a flathead screwdriver to remove the small brass screw located in the
center of the underside of the receiver (#26). See Figure 29. To remove the valve body, use a
flat ended wooden dowel or the eraser end of a pencil to push the valve body out of the front
of the receiver. See Figure 30.
NOTE: Make sure marker is un-cocked before continuing to step 4.
4. To remove trigger frame from the receiver, remove the two 1/8” socket allen screws (#29) under
the receiver. One is in front of the trigger guard and one is behind the grip portion of the
frame. See Figure 28. The receiver then will disassemble from the trigger frame.
IMPORTANT: Valve body O-rings and front valve portion of the receiver
must be well oiled prior to valve body insertion.
1. Before disassembling the marker remove the air source, then remove all paintballs from the marker,
barrel, and loader.
2. Unscrew the ASA Slug to access
the cup seal assembly. See Figure
25. Remove the valve spring, cup
seal assembly, and guide as in
Figure 26.
Figure 26Figure 25
Manual_Piranha_6.0_eng_fr_sp.qxp 2/6/08 5:03 PM Page 14