Product Manual

Receiver Continued...
To turn the 800-HL receiver
ON, simply turn the sensitiv-
ity knob until it clicks.
The higher the number on
the knob, the more sensitive
the receiver is.
Higher No. = More
sensitivity
Both the audio speaker and the meter let you know when the
receiver is over a conductor.
When the needle on the meter reaches 10 it is at peak
signal. Beyond 10 the signal becomes saturated and you
need to lower the sensitivity.
To save battery life, the Receiver turns itself OFF after 5
minutes of no use. To reset the Receiver and turn it back
ON, simply turn the switch OFF and back ON.
The sound the receiver makes is as follows:
High Pitch = close to conductor
Low Pitch = moving away from conductor
Beeping = sensitivity is too high
9