Product Manual

This System Check not only verifies the condition of your bat-

teries but also the performance of your Pipehorn. This should

be a routine check made each day before you begin your lo-

cate. Knowing if your Pipehorn is operating to standards be-

fore you begin your locate will save you time and money.

Check High-Frequency

Place the Transmitter on the ground but not over a conductor and

turn it ON. Set the Receiver to receive High-frequency and set the

sensitivity to minimum (lowest number without turning it off). Starting

up next to the Transmitter as shown, the Receiver should be beep-

ing. Move it in a line away from the Transmitter. The beeping should

stop between 3 to 7 feet. The Transmitter should be making a High

pitch tone.

Check Low-Frequency

Hook the Conductive Cables together and plug them into the Trans-

mitter. Turn both the Receiver and Transmitter ON. Stretch the wires

out to form a Circle. Set the Receiver to receive Low-Frequency and

set the sensitivity to 2 on the knob. Position the Receiver in line with

one of the wires. The Receiver should be beeping and the Trans-

mitter should be making a High pitch tone.

If the Receiver volume is low replace the batteries. If your Pipehorn

does not perform as above, replace batteries and try again. Other-

wise it may be in need of service or calibration.

EQUIPMENT CHECKS