Product Manual

This technique is beneficial in finding conductors with

unknown locations, and with no access points. Basically

you use the equipment in a way that scans the entire

ground to find all conductors in a specific area. Please

read the instructions for inductive locating before proceed-

ing.

Position the Transmitter

Lay the 800-HL Transmitter on its side, as shown below. This

will “flood” the area with signal. Turn ON the Transmitter.

Set Up the Receiver

Set up with the receiver the same as you would during induc-

tive locating. Move 5-10 feet from the transmitter, face the

transmitter with the antenna near the ground, and turn the re-

ceiver ON. Set the sensitivity control to get a LOW growl

tone.

Locate the Conductor(s)

With the receiver facing the transmitter, walk in a circle around

the transmitter. Keep a steady distance from the transmitter

and from the ground. Listen for the HIGH pitch tone areas, DO

NOT adjust the sensitivity. After locating the HIGH pitch areas,

go back and pin-point the conductors in those areas. You may

need to re-adjust the sensitivity at this step, looking for the LOW-

HIGH-LOW sound change. Mark the places with the highest

tones for further pinpointing later.

SEARCH AND SWEEP

One Person