Product Manual

Set Proper Sensitivity & Scan the Area

Adjust the sensitivity knob to get a solid, non-beeping tone from

the receiver. Scan to the left or right to find the stronger signal.

The higher pitch sound indicates you are getting closer to the

conductor, a lower pitch sound indicates you are moving away

from a conductor. If the sound starts beeping, lower the sensi-

tivity and continue scanning.

Pinpoint the Conductor

When scanning and the sound peaks, or changes from LOW

to HIGH to LOW pitch, then you have come across the con-

ductor. Be sure the tone dies off evenly on both sides of the

peak (letting you know you have a balanced signal). The peak,

or highest pitch, indicates when the antenna is directly over the

conductor as described on page 11.

Determine Source of Signal

After pinpointing, raise the receiver antenna and point it at the

transmitter. If the signal does not get significantly weaker, then

the signal is coming through the air from the transmitter more

so than from the conductor. There may be no conductor or you

may be too close to the transmitter. Move farther away from

the transmitter, pinpoint again, and re-check as shown below.