800-H Pipe and Cable Locator Manual

Receiver Continued...

To turn the 800-H receiver ON,

simply turn the sensitivity knob

until it clicks.

The higher the number on the

knob, the more sensitive the re-

ceiver is.

Higher No. = More sensitivity

The sound the receiver makes is as follows:

High Pitch = close to conductor

Low Pitch = moving away from conductor

Beeping = sensitivity is too high

Both the audio speaker and the meter let you know when the

receiver is over a conductor.

When the needle on the meter reaches 10 it is at peak signal.

Beyond 10 the signal becomes saturated and you need to lower

the sensitivity.

To save battery life, the Receiver turns itself OFF after 5 minutes

of no use. To reset the Receiver and turn it back ON, simply turn

the switch OFF and back ON.