Product Manual

4.2 Locating Property Markers
When locating property markers, the peak
signal will occur when the Mag Horn is directly
over the marker or pin. This is assuming the
marker is in a vertical or near vertical position. If
the marker is lying in a horizontal position you
will receive two peak signals, one at each end of
the marker.
After you have located the marker, use the “X”
pattern described earlier in the manual to better
pinpoint the center of the marker.
The magnetic field in highly magnetized mark-
ers can provide three peak signals. Two weak
signals to each side and a stronger signal
directly over the pin. Care should be taken to
make sure you have swept all the way across
the pin to locate the strongest signal.
Turning your sensitivity down as you start to
detect the marker will help you eliminate weaker
signals.
9