Use and Care Manual

RESTORE END TABLE SET
NEED HELP OR ADVICE ON PUTTING THIS KIT TOGETHER? MISSING PIECES?
EMAIL US AT [e-mail] FOR ANY QUESTIONS
B
A
C
D
E
A
PARTS LIST
370ET01
370ET02
370ET03
370ET04
A- 1/2 IN. FLANGES 8
B- 1/2 IN. TEES 4
C- 1/2 IN. 10 IN. PIPE 4
D- 1/2 IN. 8 IN. PIPE 4
E- 1/2 IN. 12 IN. PIPE 2
included
F- WOOD END TABLE
1/2 IN. SCREWS 16
This kit is made of industrial grade authentic pipe. It is coated in oil post production to prevent rust.
The kit should be cleaned and sealed to prevent rusting. See Clean and Seal sheet for more
information on cleaning and sealing your pipe kit or watch the clean and seal video on the listing.
RECOMMENDED
DRILL FOR
INSTALLATION
RECOMMENDED TOOLS
RECOMMENDED
DRILL FOR
INSTALLATION
recommended flange placement
INSTALLATION INTO WOOD TOP
1. Put legs together as shown above. Hand tighten each
flange to the pipe.
2. Using a drill, screw legs into the tabletop. We recom-
mend using setting #10 to prevent stripping the
wood. There is no need to pre-drill.
3. You can untighten each flange to help level the table.
TAKING CARE OF YOUR SOLID WOOD TOP
RESTORE by PIPE DÉCOR wood tops use a water-based
polyurethane topcoat, to protect and add sheen.
CLEANING
Use a damp rag and gentle dish soap like Dawn.
DO NOT USE Oil-based cleaners, such as Murphy Oil Soap
or acetone cleaners. DO NOT USE an excess amount of
water on your wood top.