Instructions / Assembly

24”/36” SHELVES WITH STRAIGHT BRACKETS (2 SHELVES)
NEED HELP OR ADVICE ON PUTTING THIS KIT TOGETHER? MISSING PIECES?
EMAIL US AT [e-mail] FOR ANY QUESTIONS
# 37024SB1, 37024SB2, 37024SB5, 37024SB6, 37024SB8, 37024SB9,
37036SB1, 37036SB2, 37036SB5, 37036SB6, 37036SB8, 37036SB9
ID: 17907
(FOR 24” SHELVES)
PART DESCRIPTION QTY
A CAP 4
B FLANGES 4
C 8” NIPPLE 4
D1 24” WOOD SHELF 2
E 1 3/4” SCREWS & WALL ANCHORS 16
(FOR 36” SHELVES)
PART DESCRIPTION QTY
A CAP 6
B FLANGES 6
C 8” NIPPLE 6
D2 36” WOOD SHELF 2
E 1 3/4” SCREWS & WALL ANCHORS 24
• Place flange against wall in desired location and mark holes with pencil
• Using stud finder, locate and mark wall stud if found
A) If a wall stud is present, attach flange to wall with included screws
b) If no wall stud is present:
• Drill pilot holes in wall using ¼” drill bit
• Insert anchor fully into pilot hole using hammer and Phillips screwdriver as needed
• Attach flange to wall using included screws
HOW TO PREVENT PIPE CORROSION
PIPE DECOR industrial-grade black pipes and fittings are coated with a rust-preventive oil during manufacturing. For best
results,
SEAL THE PIPES TO AVOID ANY RUSTING after cleaning the kit.
CLEAN AND SEAL INSTRUCTIONS:
CLEAN: Recommended supplies: regular degreasing dish soap, washcloths, gloves (optional)
1. Wash your pipes and fittings with warm water and dish soap until the oil is completely removed.
2. Wipe the pipes with a dry washcloth and wait until the pipes are completely dry.
IMPORTANT: THE PIPES MUST BE COMPLETELY DRY BEFORE YOU START THE SEALING PROCESS.
SEAL:
if using polyurethane spray: Spray each dry pipe and fitting with a polyurethane matte or satin finishing spray and let it
dry before assembling the kit.
if using finishing wax: Coat each dry pipe with a finishing wax. Wait for 20 minutes, then polish the pipe with a dry washcloth by
wiping them down. Faster wiping will result in a shinier finish.
D1: 24” WOOD SHELF (ONLY FOR #37024SB)
D2: 36” WOOD SHELF (ONLY FOR #37036SB)
A
B
C
E